Texas Instruments TAS5110D6REF Manual de usuario descargar pdf (Pagina 13)

PCB Key Map

1-5

Introduction

- H-bridge outputs (OUTPUTA and OUTPUTB) are in a high-impedance

state (Hi-Z state).

- ERR_RCVY at the PWM processor is forced low by the SHUTDOWN

signal.

- RESET at the TAS5110 is forced low by the VALID signal.

- The VALID signal goes high after 4 ms and then the TAS5110 starts

switching again.

Figure 1–3. Auto Recovery Loop

EXTERNAL_ERR_RCVY

PWM Processor

ERR_RCVY

VALID

TAS5110

RESET

SHUTDOWN

Buffer

SHUTDOWN-FILTERED

Low-Pass Filter

AND

Gate

The autorecovery loop is closed when the TAS5110D6REF board is

connected to the TAS5026REF or TAS5036REF module.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 44 45

Sin comentarios

Texas Instruments TAS5110D6REF Manual de usuario Pagina 13